[. . . ] Direct the remote control towards the set and try to switch it off by pressing the key G. If the set you want to control switches off, press OK to memorise the code. Should the set not switch off, press key G repeatedly, until the set switches off. Between pressing the keys, be sure to leave enough time for the indicator light to go out and then relight (about 1 second). [. . . ] It is therefore possible, for example, to allocate SAT mode to the DVD key. You must enter the code corresponding to the manufacturer and the device by using one of the methods indicated in this manual. However, method D (automatic search for a code) will greatly simplify the task for you. In this case it is only necessary to enter a code from the list that This universal remote control (6 in 1) is compatible with the majority of television sets, DVD players and video recorders, amplifiers and Hi-Fi and Home Cinema systems, as well as digital boxes such as satellite or cable receivers, DVBT receivers (Digital Video Broadcast Terrestrial), ADSL decoders, and so on. This remote control was programmed in the factory, so that you can use it to control most of the sets of the THOMSON group's make. For this reason, we recommend that prior to attempting to programme the remote control, you try it out by means of one of the methods described in this user manual. However, first of all, you must install 2 batteries (AAA) in the remote control. Please keep this guide along with the code list (provided separately), so that you can subsequently programme your remote control for use with other sets. While the indicator is lit, enter the first digit of the 4-digit code proposed for the set to be controlled (example: 0036 for Thomson). Direct the remote control towards the set and try to switch it off by pressing the key G. Check of the programming: In principle, your set is ready for receiving the remote control commands. ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder. Hold the SETUP key down until the red indicator lamp blinks and then remains lit. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. If a second code programming is required, then repeat steps 2 and 3 above. Placing all devices on standby Press the G key twice in less than one second, keeping it held down the second time. All the devices go on standby one after the other (the devices which were already on Standby may turn on). Adjustment of ALL volume controls under a specific mode In its delivered state, the ROC6306 is programmed such that all modes will use their own Volume and Mute functions if present. You can allocate the volume control to one of the modes of the remote control on condition that the volume control exists on the corresponding device (e. Hold the SETUP key down until the red indicator lamp blinks and then remains lit. ) corresponding to the device whose volume will always be controlled by the VOL and H keys. [. . . ] When exchanging the batteries, it may be necessary to reprogram the unit. Hold down the SETUP key until the red indicator light blinks and then remains lit. Press the key that corresponds to the type of equipment you want to find the code: TV: television set, DVD: DVD player, VCR: Video recorder, SAT: satellite receiver, cable, DVBT, ADSL, AMP: audio equipment and AUX: any appliance. Press the number keys (0 to 9) until you notice that the indicator lamp blinks once. [. . . ]